High Build Epoxy Intermediate Coating Suitable For Application At
|-A two pack high build epoxy coating.|
|-Suitable for application at low temperature.|
|-VOC less than 200g/L|
|-For use in atmospheric environment protection|
|-For use at offshore facility, chemical plant, and wind power
|Typical Film Thickness||200 microns dry (250microns wet)|
|Theoretical Coverage||4m2/L at typical film thickness|
|Method of Application|
|Tip size range|
|Air Spray||Tip size range||2.0-3.0mm|
|Brush/Roller||For small area only|
|Thinner||Not recommended. Use only in exceptional circumstances (volume 5%)|
|Overcoating Data Substrate Temperature|
|Min Max||Min Max||Min Max||Min Max|
|Storage||Store in cool and dry conditions. Well ventilate. Keep away from
hot and fire. Shelf Life: 12 months minimum at 25℃. Subject to
|Pack Size||Part A||22kg/13.5L in 20L container|
|Part B||6.5kg/6.5L in 9.25 L container|
|Flash Point||Part A||Greater than 31℃|
|Part B||Greater than 28℃|
|Mixed paint||Greater than 31℃|
All surfaces to be coated should be clean, dry and free from
The primer surface should be dry free from all contamination and
725-H53-87 must be applied within the overcoating intervals
specified (consult the relevant product data sheet).
Areas of breakdown, damage etc., should be prepared to the
specified standard (e.gSa2½(GB/T 8923.1-2011)or Abrasive Blasting,
or Power Tool Cleaning) and patch primed prior to the application
Metallic Zinc Primed Surfaces
Ensure that surface of the primer is clean, dry and free from
contamination and zinc salts before application of 725-H53-87.
Ensure zinc primers are fully cured before overcoating.
This product will not cure adequately below -10℃. For maximum
performance ambient curing temperature should be above -5℃.
In common with all epoxy base coatings, 725-H53-87 will exhibit
chalking of the firm on UV exposure.
Apply in good weather. Temperature of the surface to be coated must
be least 3℃ above the dew point when the humidity is lower than
The dry time and overcoating interval may change according to the
Avoiding absorb the solvent steam and paint steam for long time.
Skin and eyes must avoid contacting the paint. Pay attention to
ventilate and fireproof when applying.
|The data in the sheet base on the information from the laboratory
and practice. The application may exceed the control, so we only
ensure our product quality. We own the right of the data sheet
modification without informing.|